No recommendation pinned yet, leave a comment to show your support for the show!
: If you must connect two rails, use Guide Rail Connectors. While functional for long rips, a single long rail is always more accurate.
This system allows for repeatable parallel cuts without manually measuring and marking each piece.
: Always start with a clean "reference edge" by trimming the factory edge of your plywood before making parallel cuts. UwzCWe4JQ2VYrg4oyh4
: If you plan to use the Festool LR 32 Hole Drilling System for cabinet shelf pins, it is better to buy "holey" rails initially rather than buying standard ones and replacing them later. 2. Festool Parallel Guide System (FS-PA/FS-PA-VL)
: The set includes a Parallel Guide (main extension) and Extensions for wider cuts. Installation : Slide the bracket into the rear groove of the guide rail. : If you must connect two rails, use Guide Rail Connectors
: Recommended for ripping 8-foot sheets or edge-jointing lumber up to 9 feet. It provides a single, perfectly straight reference edge that is more reliable than connecting two shorter rails.
: When using an MFT/3 Multi-Function Table, ensure the guide rail is long enough to clear the board at both the start and end of the cut to prevent kickback. 4. Alternatives & Enhancements Festool Parallel Guides : Always start with a clean "reference edge"
: The standard for cross-cutting 4-foot sheets.